具有变频器的矿井低压漏电保护研究

为了解决移动变电站低压侧为变频器供电时漏电保护装置误动的问题，提出了基于傅式算法的附加直流原理漏电保护新方法。通过理论分析和MATLAB/Simulink仿真，研究了具有变频器的矿井低压供电系统附加直流原理漏电保护，提出由傅式算法分解出采样电压直流分量以反映电缆绝缘水平的保护方法；同时分析了其他因素对直流分量的影响。研究结果表明:变频器对传统附加直流保护整定值有较大影响，易造成漏电保护装置误动且无法实现电缆的在线绝缘监测；所提出的直流分量法能准确测量电缆对地绝缘电阻，且可消除电缆分布电容、变频器载波频率、变频器输出频率等其他因素的干扰；采用该漏电保护方法，可承受变频器投入时对采样电压造成的较大冲击，不必在启动期间解除漏电保护装置，能够消除在此期间存在的人身触电安全隐患。     

Distribution,source, and environmental risk assessment of phthalate esters (PAEs) in water,suspended particulate matter,and sediment of a typical Yangtze River Delta City,China

Phthalates (PAEs) in drinking water sources such as the Yangtze River in developing countries had aroused widespread concern. Here, the water, suspended particulate matter (SPM), and sediment samples were collected from 15 sites in wet and dry seasons in Zhenjiang, for the determination of six PAEs (DMP, DEP, DIBP, DBP, DEHP, and DOP) using the solid-phase extraction (SPE) or ultrasonic extraction coupled with gas chromatography-mass spectrometry (GC-MS). The total concentrations of six PAEs (Σ₆PAEs) spanned a range of 2.65–39.31 μg L^?1 in water, 1.97–34.10 μg g^?1 in SPM, and 0.93–34.70 μg g^?1 in sediment. The partition coefficients (K_d1) of PAEs in water and SPM phase ranged from 0.004 to 3.36 L g^?1 in the wet season and from 0.12 to 2.84 L g^?1 in the dry season. K_d2 of PAEs in water and sediment phase was 0.001–9.75 L g^?1 in the wet season and 0.006–8.05 L g^?1 in the dry season. The dominant PAEs were DIBP, DBP, and DEHP in water and SPM, DIBP, DEHP, and DOP in sediment. The concentration of DBP in water exceeded the China Surface Water Standard. The discharge of domestic sewage and industrial wastewater might be the main potential sources of PAEs. The risk quotient (RQ) method used for the risk assessment revealed that DBP (0.01 < RQ < 1) posed a medium risk, while DIBP and DEHP (RQ > 1) posed a high environmental risk in water, DIBP (RQ > 1) also showed a high risk in sediment.

     

Sulfur cycle as an electron mediator between carbon and nitrate in a constructed wetland microcosm

• Fe(III) accepted the most electrons from organics, followed by NO₃^‒, SO₄^2‒, and O₂. • The electrons accepted by SO₄^2‒ could be stored in the solid AVS, FeS₂-S, and S⁰. • The autotrophic denitrification driven by solid S had two-phase characteristics. • A conceptual model involving electron acceptance, storage, and donation was built. • S cycle transferred electrons between organics and NO₃^‒ with an efficiency of 15%. A constructed wetland microcosm was employed to investigate the sulfur cycle-mediated electron transfer between carbon and nitrate. Sulfate accepted electrons from organics at the average rate of 0.84 mol/(m³·d) through sulfate reduction, which accounted for 20.0% of the electron input rate. The remainder of the electrons derived from organics were accepted by dissolved oxygen (2.6%), nitrate (26.8%), and iron(III) (39.9%). The sulfide produced from sulfate reduction was transformed into acid-volatile sulfide, pyrite, and elemental sulfur, which were deposited in the substratum, storing electrons in the microcosm at the average rate of 0.52 mol/(m³·d). In the presence of nitrate, the acid-volatile and elemental sulfur were oxidized to sulfate, donating electrons at the average rate of 0.14 mol/(m³·d) and driving autotrophic denitrification at the average rate of 0.30 g N/(m³·d). The overall electron transfer efficiency of the sulfur cycle for autotrophic denitrification was 15.3%. A mass balance assessment indicated that approximately 50% of the input sulfur was discharged from the microcosm, and the remainder was removed through deposition (49%) and plant uptake (1%). Dominant sulfate-reducing (i.e., Desulfovirga, Desulforhopalus, Desulfatitalea, and Desulfatirhabdium) and sulfur-oxidizing bacteria (i.e., Thiohalobacter, Thiobacillus, Sulfuritalea, and Sulfurisoma), which jointly fulfilled a sustainable sulfur cycle, were identified. These results improved understanding of electron transfers among carbon, nitrogen, and sulfur cycles in constructed wetlands, and are of engineering significance.     

Functional wastepaper-montmorillonite composite aerogel for Cd2+ adsorption

Environmental Science and Pollution Research - In this study, a composite aerogel (WP-MMT) composed of wastepaper (WP) and montmorillonite (MMT) was prepared by ambient pressure drying technology...     

汽车用聚合物材料火灾燃烧特性研究

为研究车用聚合物材料的燃烧特性，并对材料的火灾危险性进行全方位的评估，采用锥形量热仪，对汽车上常用的ABS，PP-PVC，PVC革-无纺毡以及无纺布-PVC聚合物材料进行分析表征，测得点燃时间、热释放速率、总热释放量、质量损失速率、烟气生成速率等参数。结果表明:ABS材料的点燃危险性相对最低，PVC革-无纺毡材料相对最高；随热辐射强度的增加，各样品的热释放速率和烟气生成速率明显加快；结合热释放速率峰值、均值和总热释放量可知，无纺布-PVC材料的热危险性相对最低；结合烟气生成速率和总烟释放量可知，ABS材料的发烟危害性相对最高，无纺布-PVC的相对最低；综合比较各样品的FGI和FPI值，安全等级由高到低依次为ABS，PP-PVC，PVC革-无纺毡，无纺布-PVC。     

地铁多线换乘车站火灾模型实验研究—(1)模型装置设计

为研究地铁网络化运营枢纽车站火灾烟气扩散特征和防排烟技术，根据工程资料和标准规范对典型多线换乘车站进行1∶10火灾实验模型设计，并依据设计方案完成车站模型主体结构和通风排烟系统的搭建，同时在各个防烟分区设计安装温度、流速、烟气浓度和热辐射测量装置，可实现对“T”形、“十”形和“L”形换乘等不同换乘形式车站的火灾场景模拟和危险参数测量。研究结果表明:该模型装置能够开展一系列针对不同换乘形式和通风模式的火灾实验，对于全面揭示大型换乘车站火灾烟气运动规律、验证并优化火灾防排烟设计方法、支撑复杂结构枢纽车站火灾烟气控制技术具有重要意义。     

单芯铜线过电流故障电弧熔痕的微观特征研究*

为准确认定电气火灾中过电流故障，模拟4~7倍额定电流（Ie）条件下单芯铜导线过电流故障，利用光学显微镜和扫描电子显微镜（SEM）分析过电流故障电弧熔痕的组织特征，并结合Image-Pro Plus软件测定晶粒直径、周长和面积，探究金相组织的量化判据和变化规律。结果表明:当I＝4Ie时，过电流故障电弧熔痕的金相组织主要为方向性较强的树枝晶；当I＝5Ie，6Ie时，金相组织内树枝晶占比减小，胞状晶占比升高；当I＝7Ie时，方向性较弱的胞状晶占主导。随着电流增加，晶粒的平均直径、周长和面积均呈增长趋势。通过火灾案例分析可知，实验结果与现场的电弧熔痕组织特征基本相符，验证火灾事故原因为过电流故障。     

国产铝合金表面涂层体系在多因素综合加速试验条件下的老化规律研究

研究了一种国产新型铝合金表面防护体系在多因素协同加速试验条件下的表面性能变化规律。涂层在0.01 Hz处的阻抗模值由初始的1.88×10~9 Ω下降为2.04×10~7 Ω。经历5个周期的户内多因素综合加速试验的过程中,2A97铝合金表面涂层体系的防护效果呈持续下降趋势,但5周期后尚未完全失效。     

浅谈特种飞机任务电子系统大修

随着任务电子系统在飞机领域的广泛应用,出现了一些以任务电子系统功性能为主要作战指标的特种飞机,如预警机、电子干扰机、侦察机、指挥通信机等,其载机大修在国内已经有一套成熟的标准和体系,但是任务电子系统的大修还是空白篇幅,没有相关的指导依据,本文为特种飞机任务电子系统大修的必要性、修理周期、目的、方法提供指导性建议。     

2004—2017年浙江省较大以上生产安全事故统计分析

为充分探究浙江省生产安全事故发生规律,以2004—2017年浙江省生产安全事故为研究对象,从事故发生的时间关系、区域分布、行业分布、事故类型分布等方面对全省总体、工矿商贸领域、化工领域、典型危险作业4个分类的较大以上事故特点进行了剖析研究;并从政府监管的角度,提出事故防范的措施和建议。